Industrial Utility Efficiency
The U.S. Department of Energy’s 2002 Motor Market Assessment established that pumping systems offer the greatest optimization potential of all types of fluid systems, with potential savings up to 75% and an average net savings of 20.1%. In this article, The Hydraulic Institute defines the steps for a pump system optimization.
Much attention and expense is often directed towards optimizing compressor control, clean-up equipment, system pressure / flow control and main system piping in an attempt to maintain adequate and stable pressure at the end use. Often forgotten are the components of the distribution system between the main system header and the end use.
This West Coast pharmaceutical facility has a very clean and organized compressed air system. All equipments is in good working order in the compressor room. The compressor room itself is very clean and well ventilated. The management requested a compressed air system audit for two reasons:
Most systems are sized on the supply side at many times more volume and significantly higher pressure than is actually necessary to support the real demand plus a fudge factor generally created out of fear. I am sure that had the OEM defined what is not only minimally necessary in terms of mass flow at density (pressure and temperature), but also with the intent of the highest possible efficiency, we would approach things very differently.
Compressed air users looking for energy reduction often identify their air compressors as a prime area for savings potential. But …what about end uses? There are a large number of obvious measures that can be implemented, such as leakage reduction, reducing open blowing and eliminating inappropriate uses..however, there are other more technical opportunities available that involve properly specifying or redesigning existing pneumatic circuitry in compressed air operated machines and processes.
When it comes to conserving energy in compressed air nothing is sexier than a big, old, oil-free 300 horsepower variable speed drive air compressor coupled with a heat of compression dryer tied to an energy management system with all the trimmings. If you’re like me, it’s hard not to let out a manly grunt after reading that sentence.
Swiss brush company Ebnat-Kappel uses non contact transfer technology from Bosch Rexroth to automate a problematic section of its packaging production process.
Cleanliness is often considered to be a virtue. In the beverage packaging industry, however, cleanliness is an absolute necessity.
Pneumatic system overhaul for furniture machining center yields high-precision results for a perfect, polished finish.
